Axial Xtra - Herbicide | Syngenta

You are here

Share page with AddThis
Axial Xtra

Axial Xtra

Herbicide

Authorisation Number: 
84819/111500
Composition: 
Formulation: 
Emulsifiable Concentrate | EC

For the control of key grass weeds and selective spray topping of Wild Oats in Wheat and Barley.

Other Restriction of Use

DO NOT apply if rainfall is expected within 30 minutes.

DO NOT apply to weeds under stress from factors including very dry, waterlogged, cold, frosty conditions, nutrient deficiency or the use of pre-emergent herbicides.

Mixing and spraying

Thoroughly clean the sprayer prior to use. For appropriate cleaning instructions, refer to the label of the product sprayed previously.

Fill the spray tank to half full with clean water. Start agitation. Add AXIAL XTRA by pouring it into the stream of incoming water and continue filling. Agitate while mixing and spraying. Spray solution should NOT be left standing in the vat overnight.

Mixing Order: Some products may react with other products if they are not mixed in the correct order. The general mixing order of products should be:
1. Water conditioners or buffers
2. Water dispersable granules (WG)
3. Wettable powders (WP)
4. Flowable or suspension concentrates (SC)
5. Emulsifiable concentrates (EC)
6. Water based or soluble concentrates

It is important to ensure that each individual component of the tank mix is fully dissolved and in solution before the next product is added to the tank mix, otherwise mixing problems may occur. Maintain thorough agitation during mixing and application. Agitate tank mixes vigorously if allowed to stand.

Note: Tank mix spray solutions should NOT be left standing in the vat overnight.

Ground Application:
Ensure thorough spray coverage of the target weed is obtained. Apply using 50 to 100 L of water/ha using a nozzle delivering a medium spray quality in accordance with the ASABE S572 Standard or BCPC Guideline. Spray volumes towards the higher end of the recommended range should be used for dense weed populations, where larger droplet sizes are used, or when targeting Annual Ryegrass.

Aerial Application:
Apply using a minimum of 20 L water/ha and spray at 2 to 3 m above the crop. Use a nozzle delivering a medium spray quality in accordance with the ASABE S572 Standard or BCPC Guideline. Avoid applying if wind speeds are greater than 18 km/hour.