You are here

Share page with AddThis
uniform banner



Authorisation Number: 
Activity Group: 
Group 11 Fungicide
Group 4 Fungicide
Suspo-emulsion | SE

For the control of Rhizoctonia and Pythium in Wheat and Barley, control of Stripe Rust in Wheat and suppression of Yellow Spot in Wheat.

Mixing and spraying

Half fill the spray tank with clean water and start agitation. Agitate the closed UNIFORM container prior to use. Whilst filling the remainder of the spray tank add the required amount of UNIFORM, adding any tank mix products last. Maintain agitation until spraying is complete. Uniform may be applied in a mix with liquid or coated onto granular fertilizer, or alone in an in-furrow liquid band, or as a combined in-furrow and surface band. Uniform should be used in combination with a registered seed treatment for control of seedborne disease such as smuts and bunts, e.g. Vibrance. IN FURROW APPLICATION - GRANULE FERTILIZER: Ensure treated fertilizer is dry before sowing. Treated fertilizer should be sown in the same furrow as the seed, not broadcast. Note that the flow rate of fertilizer may be changed after treatment, and the seeder should be calibrated with the treated material to ensure that the correct rates of fertilizer and fungicide are delivered. DO NOT mix seed with treated fertilizer prior to planting. Once fertilizer has been treated, protect from direct sunlight, exposure to water and extreme environmental conditions prior to planting. Treated fertilizer should not be kept for extended periods of time for more details please speak to your local Syngenta representative. Spray product evenly onto granulated fertilizer, and immediately mix thoroughly in a mechanical mixer or auger. Apply at a rate which will deposit the specific rate of the product on the quantity of fertilizer required to be sown in-furrow per hectare, using the table below as a guide. LIQUID: Uniform can be used on seeding equipment by liquid banding below or beside the seed. Uniform can be mixed with water or liquid fertilizers (ie UAN, MAP and DAP liquids). Ensure there is a separation between the seed and liquid band, use the minimum distance recommended with the fertilizer. When applying Uniform diluted in water use a minimal separation distance of 15mm. When applying Uniform as an in-furrow band, use a total solution volume of 20-100 L/ha at planting. When injecting Uniform with liquid fertilizers it is advised to use no more than 100 litres per hectare to avoid seedling damage. SPLIT APPLICATION - LIQUID IN_FURROW AND SURFACE BANDING: UNIFORM can be applied as a split in-furrow band (150 or 200 mL/ha) and surface band (150 or 200 mL/ha). With liquid in-furrow application ensure there is separation between the seed and liquid band, using a total volume of 50-100 L/ha at planting. As a surface band, apply with water using a nozzle directed over the furrow ie. inside the plant row in a total volume of 50 - 100 L/ha. Maximum amount of Uniform to be applied per hectare is 400mL.Ensure that there is a minimal separation distance of 15mm between where the seed is planted and the surface banded application. Maximum band width of surface band should be 10cm.

Tank mix lifespan

DO NOT leave the spray mix in the sprayer overnight.